Bonnet Guard/Bonnet Protector Installation:
Step1. Open Vehicle Bonnet and clean throughly where Bonnet Protector is to be fitted. Rinse and dry.
Step 2. Align the Bonnet Protector to the Bonnet. Under the Bonnet identify the 2 holes in the Bonnet Protector that align with the fasteners securing the rubber seal. Remove these fasteners.Remove the Bonnet Trim by un bolting the nuts under the Bonnet that attach the trim.
Step 3. Reposition the Bonnet Protector under the rubber seal and inline with the holes. Fasten using the Plastic Plug and Screws. Note the rubber seal is positioned on top of the Bonnet Protector so the Plastic Plug goes through the rubber seal first then Bonnet Protecotor and then into the Bonnet.
Step 4. Note the 2 central holes in the Bonnet Protector and their location on the Bonnet. Apply the Paint Protection Film to these areas.
Step 5.Fit Clips to the bonnet edge over the Paint Protection Film and into the 2 holes in the Bonnet Protector.Fasten with Quick Fit Nuts. Do NOT Over-tighten.